Trusted HVAC Services in Asheville, NC

2 Ultimate Heating Tune-Up Heat Pump: serviced and inspected heat pump system, including electrical, safeties, controls, reversing valve and defrost cycle to manufacturer specifications. Everything’s running good 16x20x4 Filterfetch.com Code Ckt-p73

Ultimate Heating Tune-Up Gas Heat: serviced and inspected gas heating system checking air flow, temperature rise, electrical, gas pressure, safeties, controls and limits, heat exchanger and venting. cleaned and checked system components to manufacturer specifications and performed combustion inspection 10x20x1 filter needs replacing

Found actuator for downstairs zone to be getting stuck in the closed position not allowing the spring pressure to open it back up. Also makes a loud buzzing noise when it’s first engaged to close Replaced and tested no other issues found

Ultimate Heating Tune-Up Heat Pump: serviced and inspected heat pump system, including electrical, safeties, controls, reversing valve and defrost cycle to manufacturer specifications. Found capacitor at the outdoor unit rated at 35+5 showing 28+5. Replaced it with a turbo tested system. Everything running as designed. The system utilizes are 22 refrigerant which is no longer manufactured along with the parts when there’s a problem with the refrigerant side of the system system

Ultimate Heating Tune-Up Heat Pump: serviced and inspected heat pump system, including electrical, safeties, controls, reversing valve and defrost cycle to manufacturer specifications Refrigerant on attic unit seems like it is good even though the coil had a leak. Super seal leak sealer seems like it’s working.

Ultimate Heating Tune-Up Gas Heat: serviced and inspected gas heating system checking water flow, temperature rise, electrical, gas pressure, safeties, controls and limits, heat exchanger and venting. cleaned and checked system components to manufacturer specifications and performed combustion inspection. Circulator pump making a rattle noise water still flowing, but will have to be replaced

Started up system heard water inside the inducer. Found drain trap to be plugged on the smaller side brought it out to the Spicket rinsed it out found a big clump of algae. Started everything up no other issues.

Replaced heat strips started and tested

Replacement of kitchen/dining zone valve cartridge and purging of air Replaced cartridge tested operation blood air out from the loop. Tested the loop to verify water flow.

Replaced Taco pump that does the left side of the building. Bleed, radiators test system verify operation. Removed and clean burner tubes. Power purged air out of left side radiator loop. All radiators are getting hot. Made sure louvers on radiators were open. I’m not sure if the beds being so close to the radiators is gonna cause an issue as far as heating the room as it probably slows down the convection through the radiators.

Found in boiler room that there is a fan on a window blowing air out from the boiler room. This must never run while the boiler is in service. In fact, louvers on that should be remained open to give this boiler more oxygen for the fire as the louvers on the door seem kind of small for a 300,000 BTU boiler. Circulator pump making a lot of noise for the left side opposite side of the boiler room. We need to replace the pump. We also will have to go around to each room on that side or possibly the whole building and blade all radiators. Also found that convectors on baseboard radiators are very dirty and damaged. This will cause Not enough heat transference from the pipes to the air through convection. Would be a good idea to straighten out all fins on the radiator and get them clean. Also on top of the baseboard there is a louver that must remain open. That’s to get the convection through the radiator into the room. It’s best if radiators weren’t blocked in anyway. Mattress that’s in b

Performed heating tune up service for heat pump system checking all electrical components, refrigerant balance, unit start up, operation, defrost, shutdown, treatment of drain, replaced customer provided filter. Will require filter change in spring: Filter 20x20x4 Can find at filterfetch.com using product code CKT-P4NY

Furnish materials and labor to apply service kit.

Performed heating tune up service for hot water radiant and heat pump systems checking all electrical components, refrigerant balance, performance of full combustion analysis, cleaning and treatment of drains and boiler components, exercising of all zones. Recommend replacement of kitchen/dining zone valve as the valve is bypassing hot water without a call for heat and will over heat the kitchen/dining zone when other zones are calling.

Performed heating tune up service on heat pump system checking all electrical components, refrigerant balance, unit start up, operation, defrost, shutdown, treatment of drains, changed customer provided filter. Everything looks and runs great!

Customer noted system making shuttering noise and turned off boiler until our arrival. Checked boiler operation - system appears to run normally at this time. Boiler internal pump amperage is .76 and is rated for .76 amps. Boiler burner appears to be degrading - recommended to replace burner with the WM maintenance kit that includes burners, gaskets, ignitors, pilots, everything included in the combustion side of the boiler.

Performed gas heating tune up service on furnace system checking all electrical components, performed full combustion analysis, checking of safeties, treatment of drains, checked out system start up, operation, shutdown. Everything looks and runs great!

Cleaned filters on ERV and tested operation of ERV system. Treated ERV condensate drain. Everything runs normally at this time. Recommend cleaning of minisplit systems in spring. Talked with Kevin about addition of a whole home dehumidifier to system - will not be able to tap into the ERV but would be able to add one potentially in crawlspace and duct in a return and supply to help address moisture issues. Kevin gave a rough estimate of $4500 but said to call and schedule an estimate so he can give an exact price.

Performed dual fuel heating tune up service checking all electrical components, refrigerant balance, unit start up, operation, defrost, shutdown, cleaning of all furnace components, treatment of drains. Everything looks and runs great!

Performed heating maintenance tune up service on gas furnace system checking all electrical components, performance of full combustion analysis, cleaning of all furnace components including burners and flame sensor, treatment of AC drain line and condensate pump. Everything looks and runs great!

Replace the site glass. Filled boiler up past heat exchanger line to verify that heating exchanger doesn’t have a leak. Drained excess water started boiler no other issues found

Removed old inducer replaced with new inducer started and tested heat furnace

Performed heating tune up service on both heat pump system and boiler system - changed customer provided thermostat for radiant heat in bedroom - checked all electrical components, refrigerant balance, performed full combustion analysis, treated all drain lines, checked all filters. Cycled systems checking start up, operation, defrost, shutdown. Everything looks and runs great!

Performed heating maintenance tune up service on heat pump system checking all electrical components, refrigerant balance, unit start up, operation, defrost, shutdown, treatment of drains, checking of humidifier. Customer complaint of unit appears to be running constantly in cooler temps and a noise at intermittent times while unit is running. Checked blower, blower operation, speed taps for both call for back up heat and regular call for heat. Checked blower operation during call for humidifier. Checked defrost and electric heat. Did not identify any unusual noises at this time. Believe system running extended cycles due to low outdoor temperatures at night as refrigerant balance and unit electrical components are within manufacturer's specifications. Adjusted thermostat cycles per hour setting to help address long cycle issues. Everything runs great!

Performed heating tune up service on heat pump system checking all electrical components, refrigerant balance, unit start up, operation, defrost, shutdown, treatment of drains. Everything looks and runs great!